Description

Tergostrip Brush-On is an aggressive, heavy duty paint remover and will effectively remove most paints and powder coatings including baked coatings, acrylic enamel, melamines, two pot epoxies and urethanes, road markings and anti-fouling marine paints.

CHEMICAL & PHYSICAL PROPERTIES

 Appearance:  Thick Opaque Cream

 Specific Gravity:  1.2

 Flammability :  Non Flammable

 Solubility in Water:  Dispersible

 pH: 2

APPLICATION

Metal surfaces

Wooden surfaces – unlike caustic strippers, Tergostrip Brush On will generally not stain or soften valuable furniture.

Removal of baked on grease from oven trays.  A thorough water rinse is essential after this operation.

Cleaning latex/bitumen glues off old linoleum and tile floors.

Stripping old markings off roads.

Removing rubber from airport runways and drives.

Stripping anti-fouling paints off boats. For fiberglass boats it is important that the stripper and loosened paint is removed promptly to minimize the possibility of the substrate being affected.

METHOD OF USE

 Ensure adequate protective clothing such as gloves, overalls and safety glasses are used.  Indoor use requires good ventilation.  Do not apply to hot surfaces or in direct sunlight.

 Open container cautiously to release pressure and begin application by spraying with nonatomising airless spray equipment or by daubing with a brush.  Allow to dwell until paint is loosened and remove with a strong jet of water (avoid back splatter).  Alternatively scrape off wrinkled film with a paint scraper and collect removed paint and stripper in newspaper.

 Tergostrip Brush On contains a wax evaporation retarder; therefore wipe stripped surfaces with a rag soaked in mineral turpentine or xylol prior to repainting.